Lanotec Steel-Seal Corrosion Protection Aerosol puts lanolin rust protection on threads, chassis rails and fittings. A 300 g can, ordered 6 at a time.

What it does

The can delivers Steel-Seal, Lanotec's lanolin corrosion inhibitor, exactly where it is needed. An evaporating carrier helps it creep into seams and threads, then leaves a film that resists acids, salts and wash off. Sprayed onto steel that has begun to corrode, it can halt further rusting, and Lanotec says the coat closes over again when scratched. Carbon dioxide drives the can, so it ships as a non flammable Class 2.2 gas.

Where to use it

4WD underbodies and chassis rails, jet skis, trailers and marine motors, boom sprayers and fertiliser spreaders, chemical store fittings and drill pipe threads. The film is non conductive to 41 kV on Lanotec's rating, so electrical parts are fine. For whole machines, the bulk Lanotec Steel-Seal Corrosion Protection goes further. See our rust and corrosion protection range.

How to use

1. Start with a clean, dry surface.
2. Shake the can well, longer when it is cold.
3. Spray an even coat and let it run into joints and threads. Wipe off any surplus.
4. Keep sparks, flames and voltage clear for roughly an hour while the carrier evaporates.
5. Wait about an hour before the part is hosed or rained on. Respray at routine services.

Safe on / avoid

Lanotec lists metal, rubber, plastic, vinyl, leather and electrical equipment as compatible. Leave new galvanising alone until the zinc has weathered grey and powdery. Spray with good ventilation and test on paint or trim first. Read the Safety Data Sheet before use.

Specifications

Pack sizes and delivery

300g aerosol in cartons of 6, the smallest order we take. Freight is quoted to your postcode at checkout. Dangerous goods freight applies.